Injection molding machine

Arburg 520S 1600-290/290

520 S 1600 - 290/290
Complete thermoplastic cylinder, 35 mm, highly wear-resistant
Complete thermoplastic cylinder, 35 mm, highly wear-resistant, for 2nd injection unit
Drive unit with 30 kW motor and 65 l/min pump delivery rate
Accumulator module with 64 l storage capacity (max. 230 bar)
Selogica direct control system
Technology level: accumulator drive
Multi-component processing
2nd injection unit 290 vertical
Open nozzle 25 mm
Open nozzle 35 mm
Open nozzle 35 mm for 2nd injection unit
Submerged nozzle tip for open nozzle
Electrical and hydraulic actuation of NVD in mold for 1st injection unit
Electrical and hydraulic actuation of NVD in mold for 2nd injection unit
Heating band for open nozzle
Heating band for open nozzle for 2nd injection unit
Heating/cooling jacket for open nozzle
Variable clamping plate set, Ø 125 mm
Minimum installation height expanded to 450 mm
Blow-out unit 1 with pressure reducer
Selection unit incl. connection
Ejector pressure P/Q controlled (prerequisite: T2)
Core pull 1, parallel movement P/Q controlled, programmable
Core pull 2, parallel movement P/Q controlled, programmable
Electric core pull control 1 (prerequisite: VE 436/00)
Top guard open, increased to safety dimension
Start-up inspection hydraulic accumulator
Continuous oil cooling and filtration
Increased cooling capacity
Parting plane device on short supports for 2nd injection unit
Nozzle contact force controlled, programmable for 1st injection unit
Nozzle contact force controlled, programmable for 2nd injection unit
Conveyor belt connection electric via socket combination
Emergency stop interface 1 to 24-pole interface, 2-channel
Emergency stop interface 2 to 24-pole interface, 2-channel
Temperature release up to 450°C and reinforced cylinder heating
Basic equipment for control of electric axes
Host computer interface ARBURG
8 programmable digital inputs/outputs on terminal strip
Interface for mold temperature control unit 20 mA
Connection cable for REGLOPLAS temperature control unit
Dcedpsxgfmyjfx Af Ien
Serial USB printer interface
External PC keyboard with USB interface
Additional floppy disk drive via USB interface
CompactFlash interface for data set storage
Operator authorization with chip card according to EUROMAP 65
Holder for PC keyboard with USB connection
Injection with mold closed ("flying injection")
3 measurement circuits for mold temperature
15 electric heating control circuits for mold heating
Device interface
Start-up parameters
Post-pressure switching channel 3 on fixed mold plate
Interface for colouring unit
LSR unit interface via 6-pin Harting connector
Interface for colouring unit for 2nd injection unit
Interface for vacuum control
Vacuum control with vent function
Vacuum monitoring via analog signal
Vacuum unit 40 m³/h
Kit for connecting mold to vacuum valve
Interface for flow monitoring for cold runner system
Energy monitoring and power consumption display
2 cooling water circuits laid to fixed mold plate
2 cooling water circuits laid to moving mold plate
4 manual cooling circuits
Basic equipment for 2nd cooling water distributor (manual)
7 manual cooling circuits for 2nd water distributor
Machine-related cooling circuits controlled
Equipment package: advanced monitoring
Equipment package: advanced movements
Equipment package: production control
Equipment package: optimization / operator aids
Equipment package: quality assurance
Equipment package: documentation
aXw Control ScrewPilot for 1st injection unit
aXw Control ScrewPilot for 2nd injection u

The listing was translated automatically. Translation errors are possible.