Plasma cutting machine

Microstep Mastercut Eco Plus 3001.15

Microstep Mastercut Eco Plus 3001.15
Year of manufacture: 2016
Controller: IMSNC
Cutting table: 3000 x 1500 mm
Extraction channel left/right
Plasma source: Kjellberg HiFocus 161i, adjustable 10 – 160 A

Power Source HiFocus 161i PLUS
• Flexible adaptation of the cutting process to required conditions thanks to soft-switch inverter and microprocessor control
• Optimal process management with ultra-fast regulation of cutting current
• Process monitoring for torch cooling, ignition time, pilot arc time, short-circuit time during torch ignition, and the power source
• Display of operating statuses and error messages via LED and display
• Analog and serial interface for adaptation to CNC controls
• Infinitely variable adjustment of cutting current from 10–160 A; marking current from 5–25 A
• Optimal piercing due to stepless delay time for main arc and adjustable current rise
• Adjustable current reduction at corners, as well as at start and end signals from guidance systems
• Automatic display of preset cutting current
• Serial data transfer for PC-based diagnostics

Plasma Cutting Technology Contour Cut
• Further development of HiFocus technology for carbon steel
• Optimized for cutting fine internal and external contours
• High cut quality and contour precision
• Holes with angle tolerances according to DIN EN ISO 9013 within range 2-4
• Low angle deviation and smooth cut surfaces
• Very good repeatability and dimensional accuracy
• No time-consuming post-processing—high productivity, reduced costs
• No additional equipment or software required, and no new wear parts necessary
• Supplied as standard

Dodpfsyzy S Aox Adasur
Plasma Torch PerCut 200/210
• PerCut 200 machine plasma torch for standard applications and high-precision bevel cutting
• Quick-change torch PerCut 210 with threaded connector for fast and comfortable setup
• Special torches available for custom applications
• Higher cutting speeds reduce cost per meter cut
• Long service life of consumables conserves resources
• Narrower kerf for less emission and waste
• Significantly lower gas consumption compared to the competition through efficient liquid cooling up to the nozzle tip
• Lower noise level due to reduced gas consumption
• Bevel cutting up to 50 degrees with standard consumables
• Cutting and marking possible with the same consumables

Technical Data:
Power source: HiFocus 161i
Connection voltage: 400 V; 3-phase; 50 Hz
Max. power consumption: 28 kVA (100% duty cycle)
Line fuse: 50 A (slow-blow)
Protection class: IP 22
Open circuit voltage: 330 V
Cutting current: 10–160 A (100% duty cycle)
Marking current: 5–25 A (100% duty cycle)
Cutting range: max. 50 mm, recommended 0.5–38 mm
Max. piercing thickness: 30 mm
Weight: 206 kg

Plasma Machine Torch: PerCut 200
Quick-change torch: PerCut 210
Clamping diameter: 50.8 mm
Plasma gases: O2, N2, Ar/H2
Marking gases: Ar
Swirl gases: O2, N2, air, N2/H2 (F5)

The listing was translated automatically. Translation errors are possible.