Stationary screwing unit screwing statioWSM Automation
Schraubstation
Machine data
- Machine type:
- Stationary screwing unit screwing statio
- Manufacturer:
- WSM Automation
- Model:
- Schraubstation
- Condition:
- good (used)
Price & Location
- Location:
- Dunkerstrasse 29, 46325 Borken/Burlo, DE
Details about the offer
- Listing ID:
- A7380038
- Reference number:
- 25069
- Update:
- 25.07.2025
Description
Assembly of parts for car radios and navigation systems and for testing them.
The assembly station is surrounded by a protective enclosure.
The service doors are equipped with monitoring switches with tumbler(interlock).
The doors are locked in automatic mode and can only be opened in automatic mode or in manual mode after pressing the Doors button on the control panel. Automatic mode cannot be started when the door is open.
Function sequence
The station is loaded with the pre-assembled module via the transfer conveyor.
The operating steps of the automatic station with the passage of a WT are described below.
In normal operation, all 3 stations work in parallel.
- Positioning of the WT with the preassembled assembly in St.2.1
- Lowering of the beam with the scanners and the vision sensor
- Scanning of the 3 codes (front panel, front LP, SD LP), comparison with the database
- Checking the correct latching of the FFC in the connector
- Lifting the carrier and lowering the WT onto the belt
- Positioning of the WT with the pre-assembled assembly in St.2.2
- Positioning of the screwdriver and screwing of the front LP
- Lowering the WT onto the belt
- Positioning of the WT with the pre-assembled assembly in pc.2.3
- Lowering of the light protection cover and contacting, positioning of the carrier with the test sensors from below
- type-dependent testing of the SD + CD lighting slots and pushbuttons
- Function test CD eject button
- Lowering the WT onto the conveyor > continue
If faults occur during the test, they are indicated on the display and can be rectified if possible.
To do this, switch to manual mode and open the doors. After the repair and starting of the automatic system, the WT is tested again in the station.
If no repair is possible (e.g. screw fault), the WT is marked as NOK in the control system and is not processed further.
Manual NOK marking and ejection is also possible.
Dkjdpfx Asibichjfzju
Seller
Registered since: 2008
Send inquiry
Telephone & Fax
Machineseeker Trust Seal
What is the trust seal?
Machineseeker certifies selected sellers with the Machineseeker trust seal. Before approval, a standardized and comprehensive check is carried out by experienced Machineseeker staff.
What do we verify?
Check of
trade licence or commercial register extract
Verification of the dealer's
postal address
Validation of the
banking details
Verification of
accessibility to
main phone number
Credit report
may not contain negative criteria
Buyer complaints
can lead to withdrawal of the sealWhat does this mean for you as buyer?
The Machineseeker trust seal enables you, as a buyer, to identify trustworthy sellers who are very likely to do honest and righteous business, without having to do your own investigation.
Disagreements may of course still arise during the purchasing process. Machineseeker is not liable for any legal violations by buyers or sellers active on Machineseeker.