Component

Bucher QR2H-008 / 2H-003R Innenzahnradpumpe SN:34460915 - ! -

Year of construction: 2005, condition: used, functionality: unexamined, machine/vehicle number: 46787, 46787 Machining center for centric turning operations on crankshafts or shaft-like components with 2 independent machining spindles. Control: Siemens 840D Tool holder: Heller turning broaching wheel 45 tool positions around the circumference Tool diameter: Ø700 in nominal dimensions – tools are not included, but can be acquired or newly manufactured for an additional charge. NC-controlled steady rest supports – without steady rests Retractable 3-jaw chuck on both sides, manufactured by Blessing Automatic loading door from above with a loading interface Dedicated chip conveyor with high discharge The machine can currently be inspected while powered on. Setup of components is possible after consultation and for an additional charge, including documentation of replacement parts and tools. Safeguarding of the control system and drives is included – delivery free to site. Rsdpfx Apszdpvgsdsch This is the machine base of a 1250mm machine; however, the usable length is limited to approximately 680mm between centers due to the main drive shaft. With a new main drive shaft, a length of over 1050mm would be possible. Year of production: 2005 Machine for centric turning operations of crankshafts or shaft-typical parts with 2 individual machining spindles Machine control: Siemens 840D Tool adapter: Heller turning broaching wheel 45 tool positions around the circumference Tool diameter Ø700 nominal – tools are not included and may be subject to a separate purchase or new procurement from the supplier. NC-controlled roller support – no workrest included Retractable 3-jaw chuck on both sides from Company Blessing Automatic gantry door for overhead loading and corresponding interface Individual chip conveyor with high drop Machine can be inspected while powered on upon request Setup of individual parts possible for a separate cost, including documentation of change-over parts and tooling Safeguarding of control and drives included – free location Machine base is DRZ1250 – effectively, on current driveshaft, limited to 680mm length; with a new driveshaft, it could be extended up to 1050mm.