Thermoforming machine for blisters

Uhlmann UPS1030ET

A used and overhauled blister machine, model UPS1030 ET (94/125)
Technical data
- Format range
Feed width maximum 142 x 255 mm
Form depth maximum 10 mm
- Output at least 15 cycles/minute
- Output maximum 70 cycles/minute PVC
- Output maximum 50 cycles/minute ALU

Includes:
- Form film roll carrier with two tension shafts, for maximum roll diameter 800mm, electromechanically foldable, including cutting and gluing table, painted neutral grey
- Continuous conveyance of the form material with a contactless loop
- Contact heating with 6 individually controlled heating zones (3 zones per plate)
- Forming station prepared for PVC or aluminum form film with 4-column guide system
- electr. Preparation for pore and crack detection (Visio-Scan)
- Clamping pliers for securing the forming film in the forming station when the machine stops
- Servo-controlled feed after the forming station, film shrinkage compensation guaranteed
- Contact cooling with servo-controlled feed
- Cooling water connection for upper and lower forming tool and lower sealing tool
- Deflection with compensation pendulum
- Filling section, approx. 1900mm with slanted brush and safety flap
- Electrical preparation SimTap 2.i and brush feed
Prjdpfxer Ii R Uj Adnjd
- Sealing station for plate sealing and toggle lever drive, with 4 column guide (reinforced version with tuning domes)
- Overload protection in the sealing station
- Upper sealing plate automatically retracts when the machine stops
- Cover film holder mounted on the back of the machine with 2 pneumatic tension shafts core diameter 76mm
- Deflection shoulder for cover film with pressure presence control
- Stretching station for cover film with touch probe controlled Stretching (print mark on the fly)
- Contact cooling station after the sealing station
- Feed before the punching station
- Embossing station
- Perforating station
- Punching station, adjustable, including blister lowering
- Waste cutter with integrated feed for immediate cutting from the waste grid
- Compressed air monitoring
- Sliding door panel, protective doors electrically switched for emergency stop when actuated 2-channel, made of plexiglass, hinged hood in the transfer area
- Switch cabinet hinged on the back of the machine Mains 400/230 volts, 3/N/PE 50 Hz with neutral conductor and separate earthing.
The stations were completely overhauled and the discontinued parts were replaced at the time of the overhaul.

- Schneider PacDrive3 system with Pac2Touch
- Machine paintwork RAL 9007

- Linear translator with:
o Lowering unit in the punching station
o Good blister outlet below the punch with slide rails
o Individual vacuum translator
o Individual ejection with ejection counter control
o Collection belt with separate drive
o Transfer belt
o Good blister clearer when the following machine is at a standstill
- CE conformity with declaration of conformity
- Two sets of operating manuals

The listing was translated automatically. Translation errors are possible.